System Features - Ibiza sound UHF10A/B Manual De Instrucciones

appliance has to be kept open and under voltage during maintenance or repairs, this work may only be carried out
by a specialist who is familiar with the risks involved and the relevant regulations.
• Never connect the appliance directly after transferring it from a cold to a warm room. The condensation water that
forms could destroy the appliance or result in an electric shock. Allow the device to reach room temperature
before connecting it. Wait until the condensation water has evaporated. This can take some hours.
• Do not place any naked flames such as those of burning candles on or next to the appliance.
• Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the appliance. Do
not obstruct the air circulation with objects such as magazines, table cloths or curtains. This prevents the
dissipation of heat from the appliance and can result in overheating.
• Only use the appliance in a moderate climate, not in tropical environments.
• All persons involved in operating, installing and servicing the appliance and putting it into service must be trained
and qualified accordingly and observe these operating instructions.
• Defective mains cables may only be replaced by specialists. Danger of shock hazard!
• Do not leave the packaging material lying around carelessly since it can become a source of danger for children
playing with it.
• The accident prevention regulations and the regulations of the employers' liability insurance association should be
observed at commercial institutions.
• If you are not sure about the correct connection or if questions arise which are not answered by the operating
instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if you are
in doubt the operating principle or the safety of the product.

SYSTEM FEATURES

1. Multiple system use: Several UHF systems can be used in the same performance space. Each system must be set to
a different frequency (frequency marked on the back of the receiver).
2. Simultaneous output use: Unbalanced 6.35mm jack plug and balanced XLR output connectors may be used
simultaneously to different external devices.
3. Range: UHF series transmitters will work at a distance of up to 50m from the receiver.
4. Noise squelch: Squelch circuit analyzes signal strength and quality to avoid interference due to environmental RF
noise.
5. Low battery warning light: A red light on the microphone(s) warns the user that there is less than one hour of
battery life left.
RECEIVER FEATURES
SINGLE CHANNEL RECEIVER