Exchange Of The Bulb; Operation; Cleaning; Accessories - Oase D 160 Instrucciones De Uso

Exchange of the bulb

Caution! Use bulbs of max. 5 Watt only.
Screw off the ball. The glass guard
can be removed by manual bending to
the side. Now, the halogen lamp can
easily be extracted from the holder and
exchanged. Following this, the glass
guard is pressed again into its seat in
the rubber base.
Before reassembly, the screw base
and the sealing washer are to
cleaned and dried.
Spare bulb for floating lamp.
Art.-Nr.: 856-008 005
The lighting means (bulbs) are not
covered by the OASE-warranty.
Lighting means are covered by the
warranty
manufacturer.

Operation

The lamp is operated by means of a
plug-type safety isolating transformer
230 V ~ / 12 V with 20 VA. In any case,
this transformer must be positioned
dry and safe against flooding. Only
safety transformers according to VDE
0551 IEC-742 EN 60742 must be used.
One transforrmer of 20 VA will be
sufficient for up to four lamps of 5 Watt
each. Additional lamps are connected
to the transformer by means of rhe
quadruple socket outlet available as
accessory.
In case of a dry installation, e.g. on top
of masonry walls or at walls or ceilings
a safety dis- tance of at least 50 cm
from inflammable parts must be
observed. The lamp must not be
covered.

Cleaning

Clean the lamp with a jet of water. Use a cloth and water for cleaning, do not
scour. Before screwing, the inside of the ball must always be dried.

Accessories

Quadruple socket outlet SL 4 Art.No. 856-025 for up to 4 lamps with one
transformer
6
Schwimmleuchte Exp.p65
GB Instruction for use
of the respective
6
be
Advice:
The ball should always be
screwed tightly into the
socket.
03.04.2003, 12:32
GB