Fcc, Industry Canada, Ift Mexico (Solo Rad-2400-Ifs) - Phonetics RAD-2400-IFS Manual Del Usuario

105542_es_05
1.8 FCC, Industry Canada, IFT Mexico (solo
RAD-2400-IFS)
FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference. This device must accept any interference
received, including interference that may cause undesired operation.
NOTE: Interference
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case, the user will be re-
quired to correct the interference at his own expense.
Any changes or modifications not explicitly approved by Phoenix Contact could cause the
device to cease to comply with FCC rules Part 15, and thus void the user's authority to ope-
rate the equipment.
Radio frequency exposure:
The device contains a radio transmitter and receiver. During communication the device re-
ceives and transmits radio frequency (RF) electromagnetic fields (microwaves) in the fre-
quency range of 2400 MHz to 2483.5 MHz.
RF Exposure Statement:
This equipment should be installed and operated with a minimum distance of 20 cm be-
tween the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
This device contains:
FCC ID: YG3RAD2400A
Industry Canada (IC)
Operation is subject to the following two conditions: (1) this device may not cause interfe-
rence, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
This device has been designed to operate with an antenna having a maximum gain of 9 dBi.
Having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
permitted for successful communication.
This device contains:
IC certificate: 4720B-RAD2400A
Para su seguridad
13 / 198
PHOENIX CONTACT