Calibration - Zipy go! Beating plus Manual De Usuario

Calibration

The distance counter relies on the step counts and your stride length (the distant
traveled with one step). While the device has a default stride length, this "Calibration"
setup for accurate distance measurements using your stride length (i.e. step counts
multiply by stride length). Since the "Calibration" requires you to walk / jog (run)
for a fixed distant for it to count your steps and derived the stride length, you need to
perform it at a track or an open field with clear distant markings.
Calibrate walking (Walk) and jogging (Run) stride length separately:
1. Press the or
2. Press the key
Note:
Default setting is 400m/0.25 mile (refer to Unit setting).
3. As in this illustration, you have selected to calibrate walking steps.
key as soon as you start to run for 400 meters; press stop as soon as you reach the
400 meters mark.
4. The device counts the number of steps you take to walk for 400 meters and uses
it in calculating walk distant.
key to return to option screen and repeat from Step 2.
key to select Walk / Run.
Press the
Walking Calibration
Completed！
key to save the calibration result or press the
26
manual English
go! Beating plus
Press the