Troubleshooting; Accessories And Spare Parts - Resol SBS 2000 Traducción Del Manual Original

6

Troubleshooting

Problem Possible causes
Pump does not prime • Pump defective
• Flushing hose or dirt fi lter blocked
• Too much air inside the pump
In this case, the pump can be vented by means of the
screw at its front side (see fi g.)
Pump does not build • Pump defective
up pressure
• Pressure hose blocked
Pump cannot be • Pump overheated (115 V~ version only)
switched on The overheat protection (thermistor) has been
triggered. Wait until the pump has cooled down, then
push in the overheat protection.
overheat protection
(thermistor)
vent screw
7

Accessories and spare parts

When ordering spare parts, state the serial number of the SBS2000.
1 Filling and fl ushing unit Article no. 29001340
2 Lid Article no. 28005030
3 2 x Wheel incl. axle Article no. 28004420
4 Fill / Drain valve Article no. 28005040
Drain valve for the tank
5 Hose set Article no. 28005010
including:
1 × fl ushing hose, 3,1 m
1 × pressure hose, 2,2 m
6 Ball valve set Article no. 28005060
for pressure and fl ushing hose
7 Dirt fi lter Article no. 28005050
8 Extension cable Article no. 28005070
5 m, DE version
2
1
8
7
5 5
6
4
3
19