KIKKA BOO MILKY WAY Instrucciones De Uso página 4

Read these instructions carefully before use and keep them for future reference.Failure to follow these warnings and the
assembly instructions could result in serious injury or death.Products need to be installed by adult and used under adult
supervision.
WARNINGS
• Your child's safety is your responsibility.
• Be aware of the risk of open re and other sources of strong heat,such as electric bar res,gas res,etc.in the near vicinity of
the cot.
• Do not use the cot if any part is broken,torn or missing and use only spare parts approved by the manufacturer.
• Do not leave anything in the cot or place the cot close to another product, which could provide a foothold or present a
danger of su ocation or strangulation,e.g. strings, blind/curtain cords,etc.
• Do not use more than one mattress in the cot.
• Do not leave a child unattended in this product. Always keep yuor child in view.
• Ensure that the product is correctly assembled before use; with the top bars locked straight,the centre foot rmly on the
ground and the mattress in position.
• Use only the mattress supplied with this product and ensure it remains in position. Do not use pillows.
• Do not allow a child to lift the sides of the mattress up.
• Position the product on a level and stable surface.
• Keep the product away from trailing cords and exes.
• COMPLIES WITH EN 716
I. PARTS CHART
1. Strap hook; 2. Entrance gate; 3. 2 mini wheels; 4. First layer; 5. Second layer; 6. Zip second layer;
II. COMPONENT: 1. Bassinet tube; 2. Mattress; 3. Main body;
III. OPENNING
1. Remove the playpen from the carry bag unfasten the velcro straps.
2. Put the four legs of the playpen open, on a at surface,while holding up the base of the playpen.
3. Pull upwards on the side rails until they lock into place.
4. Push the centre of the base of the playpen down until it is horizontally positioned and locks into place.
5. Connect the bassinet tubes.
6. Place the mattress inside the playpen with padded side facing up.
IV. TO USE AS MOM'S BED SIDE COT
1. Pull the zip down to the position you need.
2. Push this button on two ends upward,then move the top rail to the position you needed.
3. Fasten the buckle to tight the loosing bed fabric sides.
V. MAINTENANCE
Fabric parts: 1. The fabrics must be cleaned with warm water and mild soap. Completely dry before you use it. If is absolutely forbidden
to fold it and store it before it is completely dry.
2. Do not use strong cleaning agents, bleach or agents with abrasive particles, in order to clean the product. It is forbidden to clean it in a
washing machine, dryer, dry cleaning, bleach and tumble-dry it.
Plastic and metal parts
1. The plastic and metal parts must be cleaned with a damp soft cloth and dried with dry soft cloth.
2. Do not let the product exposed to the harmful effect of external factors - direct sunlight, rain, snow or wind. This may lead to damage
of the metal and plastic parts and fading of the fabrics.
3. When you are not using the product, store it at a dry and well ventilated place, not in dusty, humid premises with very high or very
low room temperatures.
ENGLISH