Fm/Am; Stereo/Mono; Memory And Preset; Auto (Autotune) - Vieta Home VH-HT010 Manual De Usuario

OPERATION AND FUNCTIONS

FM/AM

As this tuner can receive both normal FM radio and AM,
it features a function that can switc between the two
reception types. To switch between FM and AM, you
must either press the FM/AM button on the front panel
or the FM / AM button on the remote control.

Stereo/Mono

In some areas not all stations can be recieved noise
free, because it is not possible to get a strong enough
antenna signal.
In this case there will be a lot of noise on some
radio stations. It is possible to reduce the noise quite a
bit by listening to the radio station in mono in stead of in
stereo. This can make the radio station acceptable
to listen to. Change to mono by pressing the ST/MO
button on the remote or the ST/MONO button on the
front panel. To change back to stereo again, simply
press the button once again.
Note: there's only MONO in AM mode.

MEMORY and PRESET

1. When you have found the station and want to save
a channel under one of the presets you must press the
button on the remote control with the desired number
0,1~ +10 on the remote control for 1 second.
Note:
+10 key could be pressed by 10+
e.g.10, press +10 button and 0 button;
eg.15, press +10 one time and then 5 to save as preset
15), eg. 25, by 2 times pressing +10 and then 5.
2. You can also save the tuned station by the buttons
in the front panel, firstly to press PRESET + or - , then
press MEMORY button.
30
FM/AM switch
Stereo/Mono switch
1. Memory with number bottons
and 6 or 5 on remote control;
2. Memory with PRESET +/- buttons
on the front panel.
Tuner FM/AM

AUTO (Autotune)

When the unit has been turned on, channels must be
saved. This is done by means of the autotune
function.
To use the autotune function through the front panel
controls, press the AUTO button. All available
channels on the current tuner band will be saved.
You can also press the AUTO button on the remote
control.

TUNING

When the unit is turned on for the first time, all settings will be default settings. The settings can be changed
according to your preference. When the unit is turned off the next time, these settings will naturally be saved
as the new default settings. This also applies if you unplug the unit.
If you want to manual tune a channel, you must
press the 6 or 5 button on the remote control, or turn
the tuning knob on the front panel.
For every push on the button, the frequency will
change 0,05MHz on FM and 9 Khz on AM.
To store the manually tuned channel, simply press
the Memory button on the front panel or the Memo
button on the remote. The channel will then be stored
on the current preset.

RESET

This tuner can be reset. This is used to delete
channel stored in the unit.
Press the RESET button on the front panel to
reset the unit.
Autotune, auto scan the stations
Manual tunning
Reset
ENGLISH
31