Tokai TC-146W Manual De Instrucciones página 18

1. No naked flame sources, such as lighted candles, should be placed on the
apparatus.
2. Do not place the product in closed bookcases or racks without proper
ventilation.
3. Where the mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
4. The ventilation should not be impeded by covering the ventilation openings
with items, such as newspapers, table-cloths, curtains, etc.
5. It shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
6. Do not connect FM antenna to outside antenna.
7. The unit should not be exposed to direct sunlight, very high or low
temperature, moisture, vibrations or placed in dusty environment.
8. Do not use abrasive, benzene, thinner or other solvents to clean the surface
of the unit. To clean, wipe it will mild non-abrasive detergent solution and
clean soft cloth.
9. Never attempt to insert wires, pins or other such objects into the vents or
opening of the unit.
10. Disconnect device warning: Mains plug is used as the connection, so it
should always remain ready operate.
11. Batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
12. Attention should be drawn to the environmental aspects of battery disposal.
13. Do not dispose this product into usual household garbage at the end of
its lifecycle; hand it over to a collection center for recycling the electrical and
electronic appliances. By recycling, some of the materials can be reused.
You are making an important contribution to protect our environment. Please
inquire your community administration for the authorized disposal center.
POWER SUPPLY & BATTERY BACK-UP SYSTEM
PREPARATION FOR USE
AC-DC adaptor connection: The clock radio unit can be powered by an external
AC-DC adaptor, required the output DC 5V 600mA (included).
POWER CONNECTION
Plug the AC-DC adaptor to a household outlet AC source. This unit is equipped
with a battery backup system; it requires a 3V flat lithium battery "CR2032"
(not included). Insert the battery in the battery compartment, making certain
that the positive and negative (+and-) battery terminals are attached to the
corresponding terminals on the plate in the battery compartment. If an AC power
PRECAUTIONS FOR USE
18