EMAC Oleo-Mac PW 110C Manual De Instrucciones página 15

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the machine by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the machine.
• The power supply connection must be installed by a qualified electrician and comply with IEC 60364-1.
• The power plug must be plugged into a properly installed socket. The power supply should include a residual current
device for max. 30 mA for 30 ms.
• Always check the device, the mains cable and the plug before using the high pressure cleaner. Only operate the
device when it is in good working order and has not been damaged in any way. Damaged parts must be immediately
replaced by a qualified electrician.
• Always pull the power plug out of the socket outlet before doing any work on the high pressure cleaner, before
changing the nozzle and whenever the cleaner is not being used.
• WARNING! Unsuitable extension cable can be dangerous.
• WARNING! If an extension cord is used, the plug and socket must be of watertight construction.
• Only use suitable extension cable when working outdoors. Extension cable must have a minimum cross-section of
1.0 mm .
2
• WARNING! This device was developed to be used with cleaning agents supplied or recommended by the
Manufacturer. The use of any other cleaning agents or chemicals can negatively affect the safety of the device.
• WARNING! Risk of explosion - Do not spray flammable liquids.
• WARNING! Water that has flown through backflow preventers is considered to be non-potable.
• Cable connections should be kept dry and off the ground. Always uncoil the extension cable completely to avoid
heat damage to the cable.
• WARNING! Do not use the device when other persons or animals are in the near vicinity unless they are wearing
appropriate protective clothing.
• WARNING! High pressure jets can be dangerous when the cleaner is not used properly. Do not direct the jet toward
persons, animals, live electrical equipment or the device itself.
• WARNING! Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
• WARNING! High pressure cleaners shall not be used by children or untrained personnel.
• WARNING! High pressure hoses, fittings and couplings are important components for the safety of the device.
Only use high pressure hoses, fittings and couplings that are recommended by the Manufacturer.
• WARNING! To ensure machine safety, use only original spare parts from the Manufacturer or approved by the
Manufacturer.
• WARNING! Do not use the machine if a supply cord or important parts are damaged, e.g. safety devices, high
pressure hoses, trigger gun.
• Do not pull or carry the electric tool by its mains cable. Protect the mains cable from becoming damaged by oil,
solvents and sharp edges.
• Keep your place of work tidy.
• Ensure that the switch is turned off when connecting the unit to the power supply.
• Wear the suitable work clothes.
• Check your high pressure cleaner to ensure that it is in good working order. If the cleaner is not functioning properly,
have it checked by an authorized professional. Have all maintenance and inspection work carried out only by a
qualified electrician.
• The water jet that emerges from the high pressure nozzle produces a 'kickback' on the spray handle. Therefore, make
sure that you have a solid footing and that you have a firm hold of the handle grip. In order to protect yourself from
possible flying objects (that are released due to the high pressure).
• The high pressure jet can damage vehicle tires and tire parts. Keep a distance of at least 30 cm from the object being
cleaned.
• If there is a power failure while you are using the machine, be sure to switch off the machine for safety reasons.
• The electric pump always must be able to draw on a sufficient supply of water. Dry operation causes severe damage
to the seals.
• Disconnect from the power supply before carrying out user maintenance.
• Only use original spare parts from the Manufacturer or approved by the Manufacturer.
• If the supply cord is damaged, it must be replaced by the Manufacturer, its service agent or similar qualified persons
in order to avoid a hazard.
• Never use the machine in an environment where there could be a danger of explosion. If any doubt arises, please
contact the local authorities.
• It is not allowed to clean asbestos-containing surfaces with high pressure.
• This high pressure washer must not be used at temperatures below 0 °C.
GB
15