Creative E-MU 1212M PCI Manual Del Usuario página 4

EMU QS(En).fm Page 4 Thursday, October 26, 2006 11:09 AM
Step 3: 1212M Owners - Install 0202 I/O Daughter Card
Note: This step is for E-MU 1212M owners only. 1616/1616M owners, go on to Step 5
1. Connect the ribbon cable provided with the kit between the E-MU 1010 card and the
I/O Daughter card as shown in the figure at right. The cable is keyed so it cannot be
incorrectly inserted. Seat the connector firmly in the socket and arrange the cable
neatly.
2. Secure the E-MU 0202 I/O Daughter card into the slot next to the E-MU 1010 card,
using a second screw (if necessary).
3. Replace the cover to your computer.
4. Plug the power cord and your peripheral devices into your computer and turn on
your computer.
5. Go to Section 3 - Software Installation on page 6.
Note: Step 4 is for owners of the optional Sync Card only.
Step 4: Sync Card Owners - Install Sync Daughter Card
1. Connect the ribbon cable provided with the kit between the E-MU 1010 card and the
Sync Daughter card as shown in the figure at right. The cable is keyed so it cannot be
incorrectly inserted. Seat the connector firmly in the socket and arrange the cable
neatly.
2. Secure the E-MU Sync Daughter card into the slot next to the E-MU 1010 card, using
a second screw (if necessary).
3. Replace the cover to your computer.
4. Plug the power cord and your peripheral devices into your computer and turn on
your computer.
5. Go to Section 3 - Software Installation on page 6.
4 - E-MU PCI Digital Audio System
0202 I/O Daughter Card
Optional Sync Daughter Card