GROLAB TANKBOT HW09 Manual De Instalación página 10

Connect your actuators (OUTPUTS) in the Connect your actuators (OUTPUTS) in the
following order, respec ng the posi on of the following order, respec ng the posi on of the
EN
p plug:
ES
FR
T Twist the bare wire together and trimm it
with a cu ng tool so that when it is inserted w
i into the plug it is not exposed and does not
c cause bad contact with other cables.
T To remove a wire from the plug, use a pin to
p press the hole associated to each cable
l located at the surface of the plug. Finally, pull
t the cable out of the hole to remove it.
9
Device 1
Device 2
+ -
+ -
t
d
t
o
e
l