Taking A Measurement - PiC indolor BS 150 Manual De Instrucciones

4. Turn the palm of your left hand upwards
and position the edge of the armband about
2-3 cm above the inside of your elbow.
5. If the Index line falls within the OK interval,
shown on the upper edge of the armband,
then this armband is suitable for you. If, on
the other hand, the "index" line is situated
outside the OK interval, you may require a
special armband.

Taking a measurement

1. Press the ON/OFF/START button. The entire display will be shown for about a second before
returning to "0".
2. The unit will automatically start inflating the
armband to measure your blood pressure.
During inflation the display will show a vari-
able reading of the pressure inside the arm-
band. It is very important to remain
still and quiet during measurement.
The slightest movement could result
in an inaccurate measurement.
3. When measurement is completed, the sys-
tolic and diastolic pressure and pulse rate will
be shown simultaneously.
4. Press the ON/OFF/START button to switch
the unit off. If no button is pressed, the unit
will turn itself off automatically after 1 minute.
15 15