Care And Maintenance - babymoov BOOGY Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
A2. Assembling the front wheels (a)
Press down the front wheels (a) onto the lower front part of the pushchair until you hear a click.
A3. Assembling the canopy (b)
Fix the canopy (b) to the tubes of the frame. Attach the velcro fasteners of the canopy (b) to the pushchair.
A4. Swivel wheels
Move the release clip downwards.
To block the wheels, lift right up the release clip by positioning the arrow opposite the clip.
A5. Using the brakes (c)
Press down on the brake pedals (c) with your foot. To release the brakes (c), lift the brake pedal (c) up.
Attention: put the brakes on as soon as you stop.
A6. Opening/closing the safety harness (d)
Insert the two tabs into the fastener until they fasten. Adjust the safety harness (d) so that your child is firmly secured.
To release it, press on both sides of the tabs.
A7. Adjusting the back (e)
Press down on the reclining clip of the back (e) simultaneously to lower it into the desired position. To bring it up, raise the
back to the desired position.
Attention: do not adjust the back when the child is inside the pushchair.
A8. Adjusting the footrest (f)
Press down on the two buttons either side of the footrest (f) simultaneously to lower it to the desired position.
A9. Folding up the pushchair
Firstly, lift up the rear button with your foot.
Secondly, push down on the safety clip on the right hand side of the pushchair with your foot.
Then fold up the pushchair towards to the front until it is completely locked.
To keep the folded pushchair upright, press down on the braking system at the rear of the pushchair with your foot.
B1. Fitting the rain cover (g)
Unfold the rain cover (g) and position it so that the slots are on the rear of the pushchair. Cover and fasten the velcro
fasteners.
B2. Fitting the leg cover (h)
Position the leg cover so that it goes under the footrest (f). Fix the four fasteners on the tubes of the frame of the pushchair.
Attention, if you fold up the pushchair with the leg cover, make sure you detach the two top fastenings to prevent them from
getting caught in the frame.
Composition
• Métal and PVC
• Seat: 100 % polyester

Care and maintenance

• Clean the frame with a damp cloth and mild detergent, then dry the surface thoroughly. Do not use abrasive products.
• If the parts of the frame of the pushchair have been exposed to salt water, you are advised to rinse them with tap water as
soon as possible.
• Clean the hood with a damp cloth and mild detergent. The seat cover has a washable surface – see care label. Allow to dry
thoroughly before using it again.
• Do not fold up the pushchair when it is wet and do not store it in a damp place. This would lead to mould forming.
• Do not expose the pushchair to excessive sunlight.
8
B. USING THE ACCESSORIES (supplied with the pushchair)
CARE AND MAINTENANCE
BOOGY PUSHCHAIR • Instructions for use

Publicidad

Tabla de contenido
loading

Tabla de contenido