Technical Data; Service Centre - nor-tec 80060 Manual De Instrucciones

KEY BOX WITH COMBINATION LOCK

Technical data

Dimensions: 115×95×43 mm.
Comes with 4 screws and 4 rawlplugs.
Components
1. Wheels
2. Lock button
3. Sliding door
4. Lock pin
5. Mounting holes
Mounting
Find a suitable place for mounting either
indoors or out.
Make sure there are no wires, pipes, etc.
concealed in the wall.
Mark the four holes (5) in the rear of the key
box on the wall.
Drill the holes, insert the rawlplugs provided
and screw the key box securely to the wall
using the screws provided.
How to set/cancel the code
The code is set to 0-0-0-0 at the factory.
Turn the wheels (1) to this setting and pull
the lock button (2) down to open the door.
Move the lock pin (4) on the inside of the
door to the right and upward.
Turn the wheels to the number combination
you want to use as the code.
Move the lock pin back to its original
position.
Close the door and turn the wheels to a
random number combination to lock the key
box.
Turn the wheels to the set code and press the
button to open the key box.

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
• www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding
All rights reserved. The content of this manual may not
be reproduced, either in full or in part, in any way by
electronic or mechanical means, e.g. photocopying or
publication, translated or saved in an information storage
and retrieval system without written permission from
Schou Company A/S.
GB
6