Installation Instructions; Before Installation; Installation; Electrical Connection - Foster FL F46 CASSETO Manual De Instrucciones

Installation instructions

Before installation

Check that the input voltage indicated on the
characteristics plate is the same as the voltage of
the power outlet you are going to use.
Open the drawer
accessories and remove the packing material.
Attention! The front surface of the crockery
heater may be wrapped in a protective film.
Before using the crockery warmer for the first
time, remove this film carefully.
Make sure that the crockery warmer is not
damaged in any way. Check that the drawer
opens and closes correctly. If you find any
damage, contact
Service.
Attention: the power socket should be easily
accessible after the crockery warmer has been
installed.
The crockery warmer should only be built-in in
combination with those appliances indicated by
the manufacturer. If it is fitted in combination
with other appliances, the guarantee is no
longer valid since it is impossible to guarantee
that the crockery warmer will work correctly.

Installation

To build-in the crockery warmer in combination
with another appliance there must be a fixed,
interim shelf in the housing unit to support the
weight of both appliances.
The appliance to be combined with the crockery
warmer will be placed directly on the latter without
any need to have a separating shelf.
To build-in the appliance which is combined with
the crockery warmer, follow the instructions set
out in the respective instructions and fitting
booklet.
The relevant installation dimensions are indicated
in mm in the diagrams shown at the end of this
booklet. Proceed as follows:
1. Place the crockery warmer on the shelf and
slide it towards the interior of the niche in
such a way that it is centred and completely
lined up with the front of the unit.
and take out
the Technical Assistance
2. Check that the crockery warmer's frame is
properly levelled and is sitting evenly on the
shelf.
3. Open the drawer and fix the crockery
warmer to the sides of the unit using the two
screws provided.
all the

Electrical Connection

The crockery warmer is equipped with a power
cable and plug for single phase current. We
advise that the plug is connected to a socket
that is easily accessible after installation.
If the crockery warmer is to be installed on a
permanent basis it should be installed by a
qualified technician. In such a case, the appliance
should be connected to a circuit with an all-pole
circuit breaker with a minimum separation of 3
mm between contacts.
The data necessary for the electrical connection
are described on the crockery warmer's
characteristics
compatible with those of the power outlet you are
going to use.
WARNING: THE CROCKERY WARMER MUST
BE CONNECTED TO EARTH.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to people, animals or property if these
installation instructions are not observed.
plate and these
EN
must be
13