Charging The Battery Pack; Rotating The Screen - memorex MVDP1085 Guia Del Usuario

CHARGING THE BATTERY PACK

"Low Battery" will appear on the screen when the battery is low and needs
recharging. See below for how to charge the Battery Pack.
WITH THE BATTERY ATTACHED TO THE UNIT:
With the Battery Pack attached (see previous page), and the unit turned off, insert
the small end of the AC adapter into the DC IN jack on the side of the unit. Insert
the other end (with the 2 blades) into a conveniently-located AC outlet having 120V
AC, 60Hz. The CHARGE indicator will blink red as the battery is charging and will
light solid red when charging has completed. Disconnect the AC adapter plugs
when charging has finished.
NOTES:
• Fully charge the Battery Pack for four hours before using it for the first time. After
the initial charge, it should take approximately four hours to charge.
• A fully-charged Battery Pack can operate for about four hours.
• Charge the Battery Pack at least once every three months, even if you are not
using it.
• The Battery Pack can charge only when the unit is in the OFF mode. To turn this
unit off, simply slide the POWER ON/OFF switch to the OFF position.
To rotate the screen, twist in a clockwise direction up to 180
degrees as shown in Figure 1. It is suggested that the
screen remains in a perpendicular position while it is being
rotated to avoid scratching or damaging the surface of the
unit. To return the unit to its original position, rotate the unit
in a counter-clockwise direction.
If desired, when the screen is rotated to 180 degrees, you
can fold it over onto the body of the unit as shown in
Figure 2.
POWER SOURCES (CONTINUED)

ROTATING THE SCREEN

8
Figure 1
Figure 2