Description Of Machine Parts - Sandri Garden TL 60 Manual De Instrucciones

GB
itself to prevent accidentally starting
the machine.
C18 - If the machine hits a foreign
object while working, stop the motor,
disconnect the plug cable, carefully
inspect the cutters and determine
any damage. Repair any damage
before starting the motor. Contact a
specialised after-sales centre.
C19 - In the event of the machine
producing abnormal vibrations, stop
the motor and immediately seek the
cause. Vibrations normally indicate
a problem.
C20 - Stop the motor:
20.1 Every time you leave the MO-
TOR HOE.
20.2 Before filling up with petrol.
20.3 Before adjusting the height of the
ploughshare (wait until the cutters have
stopped).
C21 - Before lifting or lowering the
wheel.
C22 - Before cleaning or removing
material from the cutters.
C23 - Move the throttle to minimum
when switching off the motor and close
the petrol cock (if fitted) after stopping
the motor.
C24 -
temperatures higher than 5 °C, to
ensure that the ground is fully
defrosted; avoid using the machine
on grounds which are too dry and
compact, as they will be very hard.
MAINTENANCE AND DEPOSIT
D1 - Make sure all the nuts and
screws are tight so the machine is
always in good operating condition.
D2 - Never place the MOTOR HOE in
20
MOTOR HOE OPERATING MANUAL
Use the machine in
closed premises with petrol still in the
tank. Petrol vapours could reach an
open flame or sparks.
D3 - Wait for the motor to cool down
before storing the machine in closed
premises.
D4 - To reduce fire risks, keep the
motor and silencer free of grass,
leaves or excess grease.
D5 - For safety reasons, replace
worn or damaged parts. Only use
original spares. Spares made by
other manufacturers could adapt
badly and cause damage and dan-
ger.
D6 - If the tank has to be emptied, do
the job in the open.
D7 - Periodically check, or have
checked by an after-sales centre, the
tightness of the cutters and motor sup-
port screws.
D8 - The MOTOR HOE cutters are
sharp and can cut the skin. Take every
precaution when working near or on
the cutters.
3. DESCRIPTION OF MACHINE
PARTS
DESCRIPTION (Fig.1)
A) Cutter rotation control lever.
B) Cutter control cable adjuster
C) Throttle lever.
D) Handlebar lock knobs
E) Starting cable handle
F) Fuel tank cap
G) Engine oil topping-up cap
H) Starter
I) Plug cap
L) Silencer
M ) Combustion engine