Intended Use - AEG SR 4327 Instrucciones De Servicio

English
42
Reverse Side
21 SET button (time)
22 HOUR button (Hours)
23 MINUTE button (minutes)
24 AUX IN connection
25 AC Mains connection
26 Battery compartment

Intended Use

This device is used for:
• The reception of radio programmes
• Playing back audio/MP3 CDs.
It is intended exclusively for this purpose and may only
be used as such. It may only be used in the manner
described in these instructions for use. The device must
not be used for commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to materi-
als or even personal injury.
The fi rm ETV – Elektro-Technische Vertriebsgesellschaft
mbH does not accept any liability for damage caused as
a result of the use of this device contrary to its intended
use.
Start-up of the device/introduction
• Please read the operating instructions carefully
before using the device for the fi rst time!
• Select a suitable location for the device, such as a
dry, fl at, non-slip surface on which it is easy to oper-
ate the machine.
• Ensure that the device is suffi ciently ventilated!
• Remove the protective fi lm from the display if it is
still present.
Power Supply
• Connect the power cable supplied (see battery
compartment if necessary (26)) to a properly installed
230 V / 50 Hz safety power socket and the mains
connector AC ~ (25) on the back of the machine.
• Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
Setting the Time (in standby mode (OFF))
• Keep the SET button (21) pressed down.
• Press the HOUR button (22) in order to set the hours.
Keep the button pressed down until the desired hour
is reached.
• Press the MINUTE button (23) in order to set the min-
utes. Keep the button pressed down until the desired
minutes are reached.
• The time is stored automatically.
05-SR 4327 AEG.indd 42 05-SR 4327 AEG.indd 42
NOTE:
Storage/display of the time is lost as soon as the elec-
tricity supply is interrupted. If you would like the time
to be displayed even when the device is not connected
to the mains, place 4 batteries of type UM2/R14 1.5 V
into the recess of the battery compartment (batteries
not supplied). To do this, open the battery compart-
ment cover on the bottom.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment (26) on the
bottom.
• Insert 8 batteries of type UM2/R14 1,5V. Please en-
sure that the polarity is correct (see the fl oor of the
battery compartment)!
• If the device is not used for a long period of time, re-
move the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are
automatically switched off .
CAUTION:
• Diff erent battery types or new and used batteries
must not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at
the relevant collection bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or
direct sunlight. Never throw batteries into the fi re.
There is a danger of explosion!
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid
upwards by the tab (6).
• Before operating the machine for the fi rst time, re-
move the transport safety device from the CD player
if it is still in place.
Volume
The desired volume can be sent using the VOLUME /
regulator (8).
Switch-off
The machine is switched off when the function selector
switch (7) is turned to the OFF position. The time display
appears. Unplug the device.
USB Connexion (19)
This device has been developed in accordance with
the latest technical developments in the USB fi eld.
Unfortunately the large number of diff erent types of
USB storage media on off er today makes it impossible to
23.03.2009 14:32:35 Uhr 23.03.2009 14:32:35 Uhr