Heliosa 66 BLACK Instrucciones De Uso página 14

➢ Use a multi-polar switch with minimum contact gaps of 3 mm when
installing the appliance.
➢ Connect the appliance to the electrical power supply only if the
system is able to provide the maximum electrical voltage and capacity
indicated on the rating plate at maximum power.
➢ Before carrying out any type of cleaning or maintenance operation,
turn the appliance off and turn the main power switch off to disconnect
it from the power supply.
➢ Should the appliance be dropped or suffer a heavy blow, have it
checked immediately by Star Progetti.
➢ When carrying out maintenance operations, never touch the bulbs
directly, but only the terminal casings. The bulb will be damaged by
contact with naked hands; in this eventuality the product guarantee will
no longer be considered valid.
➢ In the event of accidental contact with the surface of the bulb, clean
it immediately by wiping with a cloth dipped in denatured alcohol.
➢ If the appliance does not function correctly or develops a fault, turn
it off and contact Star Progetti immediately.
➢ Ensure that only genuine original Star Progetti spares are used for any
repairs. If the cable or the power plug are damaged, take the appliance
to an authorised Star Progetti service centre for replacement. Use a
cable with T180 characteristics.
➢ Switch off the appliance at the main switch: a) if the appliance does
not function correctly; b) before cleaning the outside of the appliance;
c) if the appliance is not to be used for long periods of time.
➢ Do not cover or block the appliance during use.
➢ In order to avoid creating a fire hazard, the appliance must never be
installed with the radiating elements close to or facing towards curtains,
beds or other objects or materials that are liable to burn easily; always
ensure that these objects are at a suitable minimum distance, to avoid
any risk of fire or heat damage.
➢ Never use the appliance in combination with programming devices,
timers or other devices that will switch it on and off automatically.
➢ When the connection is made directly to the main electric net: You
need to provide a device to ensure the all-pole disconnection from the
electric net with a opening distance from the contacts, allowing a
complete disconnection in the conditions of overvoltage category III, in
accordance with the installation instructions.
14