Bosch GGS 6 S PROFESSIONAL Instrucciones De Servicio página 10

Ocultar thumbs Ver también para GGS 6 S PROFESSIONAL:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
3 609 929 A28.book Seite 1 Mittwoch, 3. August 2005 1:23 13
Tool Specifications
Straight grinder
Article number
Rated power input
[W]
Output power
[W]
No-load speed
[rpm]
Grinder spindle
thread
Tool holder
[mm]
Grinding tool Ø,
max.
[mm]
Weight according
to EPTA-Procedure
01/2003
[kg]
Protection class
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of 230/
240 V. For lower voltages and models for specific coun-
tries, these values can vary.
Machine Elements
The numbering of the machine elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Clamping nut
2 Protection guard
3 Grinder spindle
4 Mounting flange
5 On/Off switch
6 Lock-on button for On/Off switch /
Safety lock against starting
7
quick-clamping nut
8 Two-pin spanner for clamping nut
9 Holding rod
Not all of the accessories illustrated or described are
included as standard delivery.
Intended Use
The machine is intended for grinding and deburr-
ing metal using corundum grinding tools. The ma-
chine is also suitable for working with knotted-
wire cup brushes.
10 • 3 609 929 A28 • 05.08
Noise/Vibration Information
Measured values determined according to
GGS 6 S
EN 50 144.
PROFESSIONAL
0 601 214 1..
Typically the A-weighted noise levels of the ma-
chine are: Sound pressure level: 86 dB (A);
1 150
sound power level: 99 dB (A).
670
Wear hearing protection!
6 800
The typically weighted acceleration is 7.0 m/s
M 14
Ø 20
125
3.9
/ II
Additionally, the general safety instructions either
in the enclosed booklet or those added in the
centre of these operating instructions must be ob-
served.
SAVE THESE INSTRUCTIONS.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
securely than by hand.
Do not work materials containing asbes-
tos. Asbestos is considered carcinogenic.
Take protective measures when dust can
develop during working that is harmful to
one's health, combustible or explosive. Ex-
ample: Some dusts are regarded as carcino-
genic. Wear a dust mask and work with dust/
chip extraction when connectable.
Keep your workplace clean. Material mix-
tures are particularly dangerous. Dust of light
metal can be inflammable or explode.
Do not use a machine with a damaged
mains cable. Do not touch the damaged ca-
ble and pull the mains plug when the cable
is damaged while working. Damaged cables
increase the risk of an electric shock.
Connect machines that are used in the
open via a residual current device (RCD).
English - 1
For Your Safety
Read all instructions. Failure to fol-
low all instructions listed below may
result in electric shock, fire and/or se-
rious injury.
Wear safety goggles.
2
.

Publicidad

Tabla de contenido
loading

Tabla de contenido