Bosch GGS 1212 PROFESSIONAL Instrucciones De Servicio página 8

3 609 929 798 - Buch Seite 1 Donnerstag, 4. September 2003 2:54 14
Tool Specifications
Straight grinder GGS ...
PROFESSIONAL
Order number
Rated input power
Output power
No-load speed
Collet Ø, max.
Spindle collar diameter-Ø
Grinding tool Ø, max.
Weight without cable, approx. [kg]
Protection class
Please observe the order number of your machine. The trade names of the individual machines may vary.
Machine Elements
The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Collet chuck
2 Clamping nut
3 Grinder spindle
4 Spindle collar
5 On/Off switch
6 Thumbwheel for speed preselection
(GGS 7 C/GGS 27 LC)
7 Clamping holder*
* Not all of the accessories illustrated or described are
included as standard delivery.
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 82 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typically weighted acceleration is 3.5 m/s
8 • 3 609 929 798 • TMS • 01.09.03
1212 7 C
0 601 212 0.. 0 601 212 7.. 0 601 215 0.. 0 601 215 7..
[W] 500 600
[W] 270 360
[rpm] 7 000 3 100 – 7 000 27 000
[mm] 8 8
[mm] 35 35
[mm] 45 45
1.6 1.7
/ II
Intended Use
The machine is designed for grinding and deburr-
ing metal using corundum grinding tools.
For machines with an electronic control: At re-
duced speed, brushes, flap wheels and grinding
belts can also be used.
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
Wear protective glasses and hearing protec-
tion.
Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
2
.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
English - 1
27 L
500
300
8
35
25
1.6
/ II / II
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
27 LC
600
360
12 000 – 27 000
8
35
25
1.6
/ II