Parts And Controls; Battery Installation - yellow jacket AccuProbe UV Manual De Instrucciones Y Funcionamiento

Parts and Controls

UV LEDs
Digital SmartAlarm
UV LED
Power ON/OFF
Audio mute
Heated sensor
Flashing LED
Flexible probe
AccuProbe UV
Tip

Battery Installation

AccuProbe UV
1. Loosen battery door screw located on the
bottom of the detector and remove door.
2. Install 4 AA alkaline batteries observing
the proper battery polarity as labeled
AccuProbe II
1. Loosen screw located at rear end of unit
and pull down hinged battery door to
open as shown.
2. Always insert all four batteries with the
proper polarity.
™
AccuProbe UV
Alarm speaker
Low battery indicator
Sensitivity level indicators
Sensitivity adjust/select
Power ON/OFF
A/C adapter jack
inside the battery compartment and
shown above.
3. Reinstall the battery door and tighten the
screw.
AccuProbe II
3