Rockwell BLADERUNNER X2 Manual De Instructiones página 11

BLADERUNNER
or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact resistant lenses, they
are NOT safety glasses.
12. SECURE WORK. Use clamps or a vise to hold work
when practical. It's safer than using your hand and it
frees both hands to operate tool.
13. DON'T OVERREACH. Keep proper footing and
balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep tools
sharp and clean for best and safest performance.
Follow instructions for lubricating and changing
accessories.
15. DISCONNECT TOOLS before servicing; when
changing accessories, such as blades, bits, cutters,
and the like.
16. REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure switch is in off position
before plugging in.
17. USE RECOMMENDED ACCESSORIES. Consult the
owner's manual for recommended accessories. The
use of improper accessories may cause risk of injury
to persons.
18. NEVER STAND ON TOOL. Serious injury could
occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
19. CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function
– check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation.
A guard or other part that is damaged should be
properly repaired or replaced.
20. DIRECTION OF FEED. Feed work into a blade or
cutter against the direction of rotation of the blade
or cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Don't leave tool until it comes to
a complete stop.
X2
®
Figure 1
Grounding methods
Grounding pin
(A)
Adapter
Grouding
means Grounding pin
(C)
Table 1
Minimum gage for cord
Volts
Ampere
Rating
120V
More Not More
Than Than
0 6
6 10
10 12
12 16
ADDITIONAL SAFETY WARNING
FOR ALL SAWS
DANGER: Coasting Cutting Tool Can Be
Dangerous – Apply brake immediately to
stop cutting tool when the switch is turned off.
WARNING: The torque developed during
braking may loosen the blade-retaining nut,
and the nut should be checked periodically and
tightened if necessary, especially after braking.
ENG
Metal screw
Cover of grouded
outlet box
(B)
(D)
Total length of cord in feet
25ft 50ft 100ft 150ft
AWG
16 14
18 16
14 12
18 16
14 12
16 16
Not
14 12
Recommended
11