Adjusting The Volume; Operating Instructions - Synaps 11009987 Manual De Usuario

Operating Instructions

To Power the unit On/Off
Insert the DC power plug into the DC jack on the side of the photo frame and connect the other end of
the AC adapter to a standard electrical outlet. Press the power switch to the "On" position and after 5
seconds the photo frame will display the main page. Switch the power button off at the end of use.
Enter Memory Card File
Press the Card Select button on your remote control in order to choose the type of memory card you
have inserted and this will allow you to review the files on the memory card.
Card Select
Press the Card Select button on the remote control to choose between memory devices and to browse
the files on the card.
Select the file that you want to play
Photo file: press the Photo mode button to select the photo file.
Music file: press the Music mode button to select the music file.
Video file: press the Video mode button to select the video file.
Play
After choosing the file mode you will see its main menu. At this point, use the LEFT/RIGHT and
UP/DOWN keys to select a file. Then press "ENTER" to play your chosen file.

Adjusting the Volume

Use the VOL+ on the remote control to increase volume, VOL- to decrease the volume after entering
the Music or Video modes during play. Press "ENTER" to play or pause the music or video files.
Adjusting the screen Brightness / Contrast / Color / Tint
Under the Setup menu, select Brightness / Contrast / Color or Tint adjustments. Use the Left or Right
buttons on your remote to adjust until you are satisfied with the appearance of the screen.
Digital Photo Frame mode and VGA mode
The Digital photo frame can be used as a computer monitor. Use a computer monitor VGA cable (not
included) to connect to the computer host. Then press the VGA/ DPF button and the digital photo
frame will display the computer's video signal on the screen.
9