Safety Definitions - Powermate PCV43.2 Manual Del Operador

Safety Definitions

• Save all instructions
Safety Alert Symbols:
The information listed below should be read and understood by the operator . We utilize the symbols below to allow
the reader to recognize important information about their safety .
Indicates an imminently hazardous situation which, if not avoided, will result in death or
DANGER
serious injury .
Indicates a potentially hazardous situation which, if not avoided, could result in death or
WARNING
serious injury .
Indicates a potentially hazardous situation which, if not avoided, may result in minor or
CAUTION
moderate injury .
Indicates a practice not related to personal injury which, if not avoided, may result in
NOTICE
property damage .
The following symbols may be found on your cultivator . Carefully read and understand their meaning .
Safety Warning Symbols:
Look for this symbol to point out important safety precautions . It means: Attention! Become Alert!
Your Safety Is Involved.
Read operator's manual before operating this machine. Failure to follow directions could result in
serious injury .
Always wear eye protection that meets or exceeds the requirements of ANSI Z87 .1 . Wear hearing
protection . Wear breathing protection .
Do not use if children or bystanders are present .
Keep hands, feet, and clothing away from rotating tines . Contact with rotating tines may result in
serious injury .
Engine exhaust contains carbon monoxide, an odorless and deadly gas . NEVER run unit indoors
or in a poorly ventilated area .
Extremely hot surface . Do not touch a hot muffler, gear box or cylinder, you may get burned . These
parts get extremely hot from operation and remain hot for a short time after the unit is turned off .
To reduce risk of fire, clean spilled gas and oil and keep unit free from debris . Gasoline is
extremely flammable . Allow machine to cool completely before refueling .
Control and Operating Symbols:
Choke Control:
Choke/Cold Start • Warm Start/Run
Fuel Primer:
Press 6 times .
Ignition Switch:
ON/RUN
OFF/STOP
Fuel Mixture:
Fuel Mixture
50:1
50:1
Unleaded Gas: 2 Cycle Oil
Caution: Do Not Use Gas
Mix with More Than 10%
(Unleaded Gas : 2 Cycle Oil)
Methanol or Ethanol
Questions? Call Toll Free at 1-800-737-2112
ENG - 2
Copyright © 2018 MAT Engine Technologies, LLC