Power Off - Albrecht MDV 100 Operación Manual

3.2 Power on and video recording
Press Power button, the yellow indicator light turns on, now the camera starts an
initialization process and after a short time it enters the standby mode. Now Press Record /
Stop button to start recording, the yellow indicator light turns on and the red indicator light
starts to flash slowly. At this time, it begins to make a video. The resolution for the video file
is 720 x 480, and the number of frames per second is 29-30fps. If you want to stop recording
press the Record / Stop button shortly. Then the camera will save the video to the Micro SD
card automatically. After saving the red indicator light remains on. You can start recording a
new video by pressing the Record / Stop button again.
Notice:
a. Please make sure a Micro SD card has been inserted, if not, the camera will power off
automatically after 30 seconds.
b. The maximum capacity of the Micro-SD card is 16GB.
c. Saving the videos needs a certain time, so please don't press the Record / Stop button
continuously otherwise the camera maybe generating incomplete files.
d. When you make a video you get the best results by focusing on the object, keeping a
distance of ~50cm and make sure the object is sufficiently illuminated.
3.3 Sound control video
Press Power button, the yellow indicator light turns on, now the camera starts an
initialization process and after a short time it enters the standby mode. Now press the
MODE button to switch into sound control video mode. Now the red indicator light starts to
flash quickly. This indicates that the sound control mode is activated. When the camera
detects an audio signal, with a level of 60 decibel or more, it starts to record a video
automatically. The recording is indicated by the red light flashing slowly. Once sound control
is triggered, it records as long as there is no sound above 60 decibel for two minutes or until
the SD card is full. If one this happens the camera will save the file and switch into standby
mode.
3.4 Time set
The detail as following:
1. build a text called TAG.TXT under the root directory of the memory card.
2. open TAG.TXT, write synchronous date according to following format:
[date] need space with newline
2009/07/22 need space with newline
12:00:00
With the next Power on the device will check and analyse TAG.TXT, then set system time
according to file time. After that the file will be deleted by the system automatically.

3.5 Power off