Appendix; Replacing The Remote Control Battery - Silvercrest LT910 Manual Del Usuario

SilverCrest LT 910

Appendix

Replacing the Remote Control Battery

1. Turn the remote control over with its underside facing upwards and open the
battery compartment tray by pulling it with your fingernail.
2. Extract the small tray with the coin-shaped battery and replace the battery with
a new coin-shaped one of type CR2025. Always pay attention to the polarity (+
and -). The battery has a small "+" icon on its labeled face. This icon must be
visible together with the "+" icon on the battery tray.
3. Insert the tray into the remote control. Make sure that the "+" icon faces
towards the underside (the face that has no buttons) of the remote control.
Insert the battery with the correct polarity into the remote control.
Never try to recharge the battery and under no circumstances throw
it into fire. Non-intended use may cause explosion and danger to
life.
Respect the environment. Old batteries do not belong in with
domestic waste. They must be handed in to a collection point for old
batteries.
Remove the battery from the remote control when you are not going
to use the device for a long period of time. Otherwise the remote
control may become damaged by the leaking battery.
English - 54