Thermostat Control; Heating Mode - Dyson AM05 Instrucciones De Seguridad

Controls
1. Power on
Each time the heating mode is activated, it conducts
a short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle
is complete, it will revert to the selected airflow speed.
On first use, the heater will default to a temperature
1°F higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set.

Heating mode

Spot heat
Select a low flow of air.
Whole room
Select a high flow of air.
For best results turn on the oscillation control.
6

2. Thermostat control

Select the desired room temperature. Pressing red
increases the target temperature, blue decreases it.
The heater will not operate unless the target
temperature is above the room temperature.
Cool air mode
Press the blue thermostat control button to change the
target temperature to 32°F. The power button light will
change from red to blue. To adjust the airflow speed use the
airflow speed control.
To return to heating mode
Press the red thermostat control button until the digital
display shows the desired target temperature. The power
button light will change from blue to red.