Sears Craftsman 917.377650 Manual Del Usuario página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Immediately
prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING" in the Maintenance
section of this manual).
2. Lubricate as shown in the Mainte-
nance section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your lawn mower handle for
storage.
1. Loosen
the two (2) handle knobs on
sides of the upper handle
and allow
handle to fold down to the rear.
2. Squeeze
the bottom
ends of lower
handle toward
each other
until pins in
handle clear the brackets
and pivot
entire
handle
assembly
forward
and
allow it to rest on mower.
• When setting
up your handle
from the
storage
position,
the lower handle
will
require
manually
locking
into the
mowing
position.
IMPORTANT:
When folding
the handle
for storage
or transportation,
be sure to
fold the handle
as shown or you may
damage
the control
cables.
Operator presence.---_:_
r,.
control b ar
/_2/) FOLD
/_/%,
////FORWARD,////
2"')
Upper handle.---..,////FOR
/]/
/./
Lower
_/
,,j_"_...../_
_
handle "------_,,/j_"
_4"_d/"J
!,
/,
'--,-_="_.;"-.-.\_
/._"_)
//
FOLD
_'_"_--_----"_
_
_
Mowing
SQ
pin
bracket
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits from forming in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Also, alcohol blended fuels (called
gasohol or using ethanol or methanol)
can attract moisture which leads to
separation
and formation of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.
1. Drain the fuel tank.
2.
Start the engine and let it run until the
fuel lines and carburetor are empty.
• Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer is an acceptable
alternative
in minimizing the formation of
fuel gum deposits
during storage. Add
stabilizer to gasoline in fuel tank or
storage container. Always
follow the mix
ratio found on stabilizer container. Run
engine at least 10 minutes after adding
stabilizer to allow the stabilizer
to reach
the carburetor. Do not drain the gas tank
and carburetor
if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE"
in
the Maintenance
section of this manual).
CYLINDER
1. Remove
spark plug.
2.
Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
3.
Pull starter
handle slowly a few times
to distribute
oil.
4.
Replace
with new spark plug.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido