Kalorik USK SFC 1 Manual De Instrucciones página 7

6) Twist the quick release Cord Wrap clockwise to un-wrap the
power cord completely, hang the cord on the handle cord wrap
for better use of the steamer when moving and cleaning, plug
into a grounded outlet.
7) The LED will illuminate when the steamer is plugged in.
NOTE: It is recommended that another high wattage appliance is
not operated on the same circuit to avoid a circuit overload.
8) Holding the steamer head flat on the floor, unlock it from its
parking position by tilting the steamer handle backwards.
CAUTION: WHEN USING STEAMER FOR FIRST TIME, PLEASE HOLD
TRIGGER IN FOR APPROXIMATELY 30 SECONDS TO PRIME THE
UNIT.
9) Slowly pass over surface to be cleaned while pressing trigger to
emit steam. It is recommended to sweep or vacuum floor prior
using the steamer.
CAUTION: TO SANITIZE AN AREA OF YOUR FLOOR, LEAVE THE STEAMER
OVER THE AREA FOR A MINIMUM OF 8 SECONDS, BUT NO
LONGER THAN 15 SECONDS. LEAVING THE STEAMER
STATIONARY POSITION FOR A LONGER PERIOD THAN
RECOMMENDED MAY CAUSE THE BUILD UP OF A PALE
RESIDUE. THIS RESIDUE CAN BE REMOVED BY USING A
DECALCIFYING PRODUCT OR WITH A FEW DROPS OF
VINEGAR (SEE TROUBLESHOOTING GUIDE)
10) When steamer stops emitting steam, after approximately 15
minutes of use, simply remove the water tank, refill, and continue
cleaning.
WARNING: NEVER RUN THE STEAMER WITHOUT WATER. NEVER DIRECT
STEAM AT ANY PERSON OR ANIMAL. USE STEAMER ON
SEALED HARD FLOOR ONLY! DO NOT USE ON WAXED
FLOORS!
11) When you finish your cleaning, unplug the power cord from the
outlet, empty the water tank, let it cool for a few minutes and
carefully remove the cloth pad from the steamer head; wind the
power cord around the Cord Wrap and store it upright in a dry
area or hang it by the storage hook.
7
USK SFC 1 - 080403