Troubleshooting - Craftsman 917.377830 Manual Del Propietário

BATTERY
Disconnect the battery from the engine
connector and charge battery 48 hours.
OTHER
o Do not store gasoline from one season
to another.
o Replace your gasoline can if your can
starts to rust° Rust and/or dirt in your
gasoline will cause problems°
= If possible, store your unit indoors and
cover it to give protection from dust and
dirt,
TROUBLESHOOTING CHART
PROBLEM CAUSE
Does not start
Loss of power
Poorcut-uneven
= Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic., Plastic cannot
breathe which al!ows condensation to
form and will cause your unit to nJsL
IMPORTANT: Never cover mower while
engine and exhaust areas are still warm.
_CAUTION: Never store the lawn
mower with gasoline in the tank inside a
building where fumes may reach an open
flame or spark° Allow the engine to cool
before storing in any enclosure.
1. Dirty air filter_
2. Out of fuel
3. Stale fuel.
4_ Water in fuel.
5. Spark plug wire is
disconnected,
6. Bad spark plug.
7. Loose blade or broken blade
adapter.
8. Control bar in released
position,
9. Control bar defective.
10. Weak Battery
!1. Disconnected battery
connector.
, i
1. Rear of lawn mower housing
or cutting blade dragging
in heavy grass.
2o Cutting too much grass.
3, Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose btade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
17
CORRECTION
!. Clear_'replace air filter,
2, Fill fuel tank.
3. Drain tank and refill with
fresh clean fuel.
4. Drain fuel tank and
carburetor and refill tank
with fresh gasoline,
5. Connect wire to plug.
6, Replace spark plug,
7. Tighten blade bolt or
replace blade adapter:
8. Depress control bar to
handle.
9. Replace control bar.
10. Charge battery.
11, Connect battery to engine.
1. Set to "Higher Cut"
position.
2, Set to "Higher Cut"
position.
3, Clean/replace air filter.
4o Clean underside of mower
housing,
& Check oil level,
6, Cut at slower walking
speed,
1. Replace blade. Tighten
blade bolt,
!2. Set all wheels at same
height
3. Clean underside of
mower housing,