Aiming Sight; Maintenance - Agrilaser Handheld V1.0 Manual De Usuario

Protected species: : Local regulations may prohibit
the deterrence of certain (protected) bird species.
Always consult local legislation before using the
Agrilaser Handheld.

Aiming sight

Aligning the aiming sight
Applicable when the red dot is not aligned
with the laser beam.
CAUTION: Do not stare into laser beam while
aligning the aiming sight.
Step 1: Preparing for alignment
Unlock the two locking screws (number 1 on the
aiming sight) at the back of the aiming sight (figure
3.1). For each locking screw, execute three full
counter-clockwise rotations with the screwdriver.
Step 2: Vertical alignment.
1. Switch on the laser and project the beam on a
distant object. Make sure that the green dot is
visible through the aiming sight.
2. Rotate the adjustment screw (number 2 on the
aiming sight) in clockwise direction to move the red
dot downwards and vice versa (figure 3.2).
Continue to the horizontal alignment after the red dot
is correctly aligned in vertical position.
Step 3: Horizontal alignment.
1. Project the beam on a distant object and make sure
that the green dot is visible through the aiming sight.
2. Rotate the adjustment screw (number 3 on the
aiming sight) in clockwise direction to move the red
dot to the left and vice versa (figure 3.3).
Step 4: Securing new position
Fasten the two locking screws (number 1 on the
aiming sight) in clockwise direction to secure the
new alignment position (figure 3.4). Do not use
excessive force.
Replacing the battery of the
aiming sight
Applicable when the red dot is not visible.
1. Unscrew the two hex screws using the hex key
(figure 4.1).
2. Remove the upper compartment of the aiming
sight from its base to replace the CR2032 battery
(figure 4.2).
3. Place the upper compartment in original position and
fasten the hex screws using the hex key (figure 4.3).
Replacing the aiming sight
Applicable when the aiming sight is defective.
1. Unscrew the locknut by hand (figure 5.1).
2. Remove the aiming sight from the body of the
Agrilaser Handheld (figure 5.2).
3. Place the aiming sight on the body of the Agrilaser
Handheld and fasten it by hand (figure 5.3).

Maintenance

Cleaning
Body (Agrilaser Handheld and aiming sight)
Use a soft dry cloth to remove dust and dirt from the
Agrilaser Handheld and the aiming sight. Do not use
any liquids.
Important: Dust and other foreign matter inside the
Agrilaser Handheld may cause damage not covered
under warranty.
User manual Agrilaser User manual Agrilaser
EN
FR
DE
NL
ES
PT
RU
9 9
Handheld Handheld
® ®