US Robotics Wireless MAXg Router Guía Breve De Instalación página 7

Troubleshooting
The Setup Wizard was unable to detect my Internet connection.
Possible Solution:
You will need to manually configure your Internet connection. There are two methods of instruc-
tions you can follow to setup your Internet connection: If you are still in the Setup Wizard or If
you have already closed the Setup Wizard.
If you are still in the Setup Wizard:
Select your Internet connection type: either Cable, DSL Router, satellite, ISN, LAN, or other or
DSL modem (also known as PPPoE). Depending on your selection, you will need to enter
some information that was provided by your ISP. After entering all of your necessary informa-
tion, click Next. Continue to follow the on-screen instructions to complete the Setup Wizard.
For more information about the settings, refer to the Web User Interface section of the User
Guide on the Installation CD-ROM.
If you have already closed the Setup Wizard:
Launch a Web browser. In the location or address line of your Web browser, type
http://192.168.2.1 to access the Web User Interface. Click the Internet tab. Select your Inter-
net connection type: either Cable, DSL Router, satellite, ISN, LAN, or other or DSL modem
(also known as PPPoE). Depending on your selection, you will need to enter some information
that was provided by your ISP. When you are finished, click Save. You should now be able to
access the Internet. For more information about the settings, refer to the Web User Interface
section of the User Guide on the Installation CD-ROM.
I am no longer able to access the Internet.
Possible Solution:
Make sure that the power cord and all the Ethernet cables are connected correctly. This includes
the cables connecting the Wireless MAXgG Router, the broadband modem, and all the computers.
Possible Solution:
Make sure that your computer is using an IP address that is within the default range of
192.168.2.2 to 192.168.2.254. Make sure the address of the subnet mask is 255.255.255.0. The
Default Gateway should be the IP address of the Wireless MAXg Router, which is 192.168.2.1. To
verify all of these settings, perform the following steps:
Windows Me, 98, or 95 Users: Click Windows Start and then Run. Type winipcfg and
click OK. Check the IP Address, Subnet Mask, Default Gateway, and DNS server data to
make sure they are correct. If the information is not correct, click Release All and then
click Renew All.
3