Tronic KH 3140 Serie Instrucciones De Uso página 7

Bomba de aire de acumulador
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
To avoid the risk of accidents and
injuries:
• Do not use the device as hairdrier –
your hair could get caught by the
device and be pulled into it!
• Do not direct the air jet in the direction
of persons or animals. Particles which
might be contained in the air jet could
meet the object at high speed and
cause injuries.
4. Charging
Charge the device completely prior to its
initial use. The accumulator is only pre-
charged to a minimum extent ex works.
Attention: The capacity (service life) of
the accumulator decreases, if it is often
charged or discharged only to half the
extent possible (socalled "memory
effect"). Therefore:
Always charge the device completely
and not only to half the extent possible.
Charge the device only if its capacity
is noticeably low and not just in between.
Avoid draining the accumulator – i. e.
do not discharge it completely. This might
destroy the accumulator.
a) Via a mains charging adapter
...
the complete charging process of the
accumulator takes 5-8 hours:
Insert the low voltage plug of the
mains adapter ...
in the left socket with the battery
symbol ...
and then insert the mains plug in the
socket. Now the device is being char-
ged!
b) Via the motor vehicle
charging cable ...
the complete charging process of the
accumulator takes 5-8 hours:
Insert the low voltage plug of the
motor vehicle charging cable...
in the left socket with the battery
symbol ...
and only then insert the motor vehicle
plug in the cigarette lighter of the car.
This sequence prevents a short circuit if
the low voltage plug which is already live
falls out of your hands.
5. Application
First place one of the supplied adapters
on the discharge nozzle at the side.
a) Via the integrated accumulator:
If the latter is completely charged, you
can switch on and off the device simply
by means of the main switch.
To do this, switch the main switch to
position II. The device turns on.
b) Via the mains charging
adapter
If the accumulator is empty, insert the
low voltage plug of the mains charging
adapter...
in the right socket with the impeller
symbol.
and then insert the mains plug in the
socket. The integrated accumulator is
not charged by this!
Switch the main switch to position I.
The device turns on.
c) Via the motor vehicle
charging cable
If the accumulator is empty insert the
low voltage plug of the motor vehicle
cable...
in the right socket with the impeller
symbol.
and only then insert the motor vehicle
plug in the cigarette lighter of the car.
The integrated accumulator is not
charged by this!
Switch the main switch to position I.
The device turns on.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido