Connecting The Control Box; Tools Required - Waeco PerfectView Accessory RV-SWITCH-SV Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
_RV-SWITCH-SV.book Seite 21 Dienstag, 10. März 2009 2:41 14
PerfectView
6

Connecting the control box

6.1

Tools required

To make and test the electrical connection, the following tools are required:
insulating tape
heat shrinking sleeve
diode test lamp (fig. 1 1, page 3) or voltmeter (fig. 1 2, page 3)
crimping tool (fig. 1 4, page 3)
soldering iron (optional) (fig. 1 5, page 3)
solder (optional) (fig. 1 6, page 3)
cable bushing sleeves (optional)
6.2
Testing the control box and components
Before you install and connect the desired components, you should test the system. In
this way you can determine whether the components work together in the way you want.
You thus avoid having to dismantle the components later.
To test the system, proceed as follows:
Lay out the individual devices.
Connect the devices as described in the following chapter, but without securing the
cables .
If necessary, connect the control cables.
Switch the system on.
Check to see whether the components are working together as desired.
If the system is working to your satisfaction, you can secure the devices and cables.
6.3
Connecting the control box
Warning!
e
Ensure that all lines are connected correctly. The control line may never be con-
nected to earth; doing so can damage the device. Make especially sure to insu-
late the bare end of the control line when it is not in use and thus not connected.
Caution!
e
If you possess a monitor that may only be used for 12 V and 24-V electrics is
being used, a voltage converter must be installed.
Connecting the control box
21

Publicidad

Tabla de contenido
loading

Tabla de contenido