Gabarron ADL 2012 Instrucciones De Instalacion Y Uso página 9

WARNING !
At the other side of this part there is a breakable panel of thermal isolation. It must be handle with
care. Avoid touching it.
fig. 2
7.- Place a row of storage bricks carefully, with the flat side heading the bottom of the heater. Insert one of the heating
lements in the holes in the right side insulation (Fig. 3).
fig. 3
fig. 4
8.- Check that the heating element rests completely on the
bricks without restricting a new row (Fig. 4).
9.- Arrange two new rows of bricks, ensuring the flat side of each bricks is facing towards the
bottom of the heater, and insert a new heating element. Repeat the operation for the third
heating element. Place the last row of bricks also with the flat side toward the bottom of the
heater. Check there is no gap between bricks.
10.- Connect the heater following the enclosed diagram. Ensure all connections are correct
and that no connection is damaged. Do not leave any remaining wire inside the heater.
fig. 5
9