Gabarron IDP-2000 Instrucciones De Instalacion Y Uso página 8

2. INSTALLATION
Open the box to take out the heater and all the accessories.
1- Insert the lower post assembly (11) into the base assembly
(16) and then fix it tightly by means of 4 M6X30 screws, and
insert the clamp (12) into the lower post (11).
3- Join the Upper Post Assembly (7) and the Middle Post (9) together with
three M5X6 screw.
5- According to the request of use angle, Heating Element
Assembly can adjust angle at 0º~45º.
2- Join the Lower Post Assembly and the Middle Post (9) together with three
M5X6 screw.
4- Join the Heating Element Assembly (1) and the Upper
Post Assembly (7) together ,then fix them tightly by
rotating the Knob, and put the power cord supply into the
clamp.
8