Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Read entre Ovmer's manual before you attemptto asserrv
hie or operate your new pressure washer. Your new pres-
sure v_sher has been assembled atthe factory _th excep-
t{on of those parts left unassembled
for shipping purposes.
REMOVE
PRESSURE
WASHER
FROM CARTON
Open the carton and remove loose parts and parts box
included with carton.
o
Cut two comers of carton and lay the end panel flat
o
Remove all packing material.
e
Roll pressure v_sher out of carton and check carton
thoroughly for additional loose parts,
Refer to Page 6, "Conten_s of Hardware
Pack" for an
iUuslrated listing of all items included with your pressure
washer. Become familiar with each piece before assem-
bling pressure washer. Check all contents against illustra-
tions on Page 6. If any parts are missing or damaged, call
the Pressure Washer Helpline at 1-800-_-3136.
PREPARING
THE PRESSURE
WASHER
FOR
FIRST USE
IF YOU HAVE ANY PROBLEMS
WITH THE ASSEMBLY
OF YOUR PRESSURE
WASHER,
PLEASE CALL THE
PRESSURE WASHER HELPLINE
AT 1-800-222-3136.
For the most part; your Sears Craftsman High Pressure
Washer has been assembled at the factor/.
To prepare
your pressure washer for operation, however, you will need
to perform these tasks:
o
Raise the Guide Handle and attach the wire basketthat
holds chemicals
Connect high pressure hose to the spray gun and the
pump and connect water supply to the pump.
Add oil to engine crankcase and add fue! to fuel tank
STEP
1
- Raise
guide
handle.
Loosen knobsto
raise handle
Tightan v_en
handle is straight
FIG. 1
STE P
2-Take
wire basketand
insert
prongs
of basket
into holes on cradle
base located behind _he engine.
/
l!
FIG.2
STE P 3
- Fit basket on axle
After you have inserted prongs into holes, swing the
basket dove. Hold basket as shown in F_g. &
i
Place your thumbs on the axle and apply upward pres-
sure so you can place bracket over the axle.
FIG. 3
Publicidad
Tabla de contenido
