Engine Oil; Troubleshooting - Craftsman 917.387560 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Empty
the fuel tank by starting
the en-
gine and let it run until the fuel lines and
carburetor
are empty.
• Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during
storage.
Add
stabilizer
to gasoline
in fuel tank or stor-
age container.
Always
follow the mix ratio
found
on stabilizer
container.
Run engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach the car-
buretor.
Do not empty
the gas tank and
carburetor
if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE" in
the Maintenance
section of this manual).
CYLINDER
1. Remove spark plug.
2.
Pour one ounce
(29 ml) of oil through
spark
plug hole into cylinder.
3.
Pull starter
handle
slowly
a few times
to distribute
oil.
4.
Replace
with new spark plug.
OTHER
• Do not store gasoline
from one season
to another.
• Replace
your gasoline
can if your can
starts
to rust.
Rust and/or
dirt in your
gasoline
will cause
problems.
If possible,
store your unit indoors
and
cover it to protect
it from dust and dirt.
• Cover your unit with a suitable
protec-
tive cover that does not retain
moisture.
Do not use plastic.
Plastic
cannot
breathe,
which
allows condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower
while
engine
and exhaust
areas
are still warm.
_i, CAUTION:
Never store the lawn mower
with gasoline
in the tank inside
a building
where
fumes
may reach
an open flame
or spark.
Allow the engine
to cool before
storing
in any enclosure.
TROUBLESHOOTING
- See appropriate
section
in manual
unless
directed
to a Sears
Parts & Repair
Center.
PROBLEM
CAUSE
CORRECTION
Does not start
1. Dirty air filter.
1. Clean/replace
air filter.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
blade adapter.
8. Control bar in released
position.
,
3.
4.
5.
6.
7.
Fill fuel tank.
Empty
fuel tank and refill tank
with fresh,
clean gasoline.
Empty
fuel tank and refill tank
with fresh,
clean gasoline.
Connect
wire to plug.
Replace
spark plug.
Tighten
blade bolt or
replace
blade adapter.
8.
Depress
control
bar to
handle.
9.
Control
bar defective.
10. Fuel valve lever (if so
equipped)
in OFF position.
11.Weak
battery
(if equipped).
12. Disconnected
battery
connector
(if equipped).
9. Replace control bar.
10.Turn fuel valve lever
to the ON position.
11. Charge battery.
12.Connect
battery to engine.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido