Descargar Imprimir esta página

SonicWALL TZ 105 Serie Comience Rápidamente página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

FCC
NOTE: This equipment was tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. And, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If thee quipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference using one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from the receiver connection.
Consult SonicWALL for assistance.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
Radiation Exposure Statement
To comply with FCC/IC RF Exposure Limits set forth for an uncontrolled environment, the product must be installed and operated with a minimum separation distance (between nearby
person(s) and radiating antenna) according to the following scenarios:
1.
20cm minimum when the product is operated alone without co-transmitting with a plug-in 3G USB dongle device.
2.
45cm minimum when the product is operated with a plug-in 3G USB device which has maximum of 7W ERP output power.
3.
For co-transmission scenario which is not covered above, please consult the RF technician or device supplier.
United States of America Authorized Channels
SonicWALL declares that the APL22-09E (FCC ID: QWU-09E) when sold in US is limited to CH1~CH11 by specified firmware controlled in the USA.
FCC
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution:
This device is for indoor usage to reduce potential for harmful interference to co-channel systems. Frequency and channels in 5.15-5.2 GHz band are restricted to indoor use by the FCC.
The APL22-09E device has been designed to operate with an antenna having a maximum gain of 4 dBi (2.4 and 5 GHs) RSMA connector. Antenna having a higher gain is strictly prohibited.
The required antenna impedance is 50 ohms.
Dynamic Frequency Selection(DFS) is required on all Wireless LAN Mater devices(usually Access Points) and Wireless LAN Clients (usually Wireless NICs) that operate within 5470 MHz –
5725 MHz. TZ 205W that have these frequencies and channels enable in this range comply with North American and International DFS requirements. Some frequencies are blocked, and
cannot be selected by theuser per each specific regional approval.
Specific to the USA; at the urging of the Federal Communication Commission(FCC) user/installers should avoid operation frequencies near Terminal Doppler Weather Radar (TDWR)
systems frequencies 5600-5650 MHz when installing TZ 205W within 35 km of line-of-site of TDWR sites. If TDWR is within 35 km the TZ 205Wt frequencies should be set to at least 30 MHz
above or below any TDWR system frequency at that site. TDWR locations and specific frequencies used can be found at <
current and background information can be found at <
DFS band function is product dependent. Some products may not have DFS band function.
http://www.wispa.org/?page_id=2341
http://spectrumbridge.com/udrs/home.aspx>
>.
. Detailed

Publicidad

loading

Productos relacionados para SonicWALL TZ 105 Serie

Este manual también es adecuado para:

Tz 205 serieTz 105w