Starline ROLDECK Manual Del Usuario página 16

User manual Starline Roldeck
The position of the Roldeck is saved
with the "light symbol" key.
After programming of the fine
CLOSE
OPEN
tuning, the S-Switch shows if
the programming is correct or
incorrect successful. With a correct
programming a "" is displayed.
When the programming is good the
PROG
"Exit" symbol can be choosen to exit
the program by pressing the arrow
keys  or . Then press the middle
key "light symbol" shortly to exit the
program.
1 sec.
The programming is complete.
Also remove the Jumper "B" from the
circuit board of the control.
Incorrect programming shows "".
PROG
This is possible when only one or no
position is programmed.
If an incorrect program, the program
must be removed first. Use the
arrow keys  or  (PROG "") and
then press the lamp symbol. The
program is deleted. Start again with
programming the Roldeck.
OR
1 sec.
RDCM V03-1015
16