Some operation problems are due to causes that can be eliminated easily without
appealing to the technical service. Pay attention to the following indications:
PROBLEM
Dryer doesn´t work
Going out of the sawdust to the
exterior
Cutlery block.
SOLUCTION AND
PROBLEMS
POSIBLE CAUSE
Is the dryer plugged in?
Power switch on ?
Does the hot air turbine work
correctly ?
Are you feeding the machine
with an excess of cutlery ?
Is it working with too used
sawdust ?
Is
vegetable
sawdust
humid ?
Have you washed the cutlery
correctly ?
Are you feeding the machine
correctly ?
Have
you
introduced
outsize piece ?
Is there a piece obstructing
the step to the other ones ?
- 10 -
SOLUTION
Plug the dryer into a grounded
outlet.
Turn the power switch on.
Place a tablespoon full of sawdust
near the exit and check if turbine
retire the sawdust to verify if it
works correctly. If it doesn´t retire
it, the turbine doesn´t work.
An excess of cutlery avoid that the
dryer carries out a good work.
Rememeber that you should feed
the machine in handfuls of 12 or 15
cutlery approximately leaving small
intervals among them.
If the sawdust have lost its initial
granulated
is
possible
adheres to place setting. In this
case
you
should
sawdust.
If you observe that the sawdust has
too
a high degree of humidity, leave the
machine working without cutlery
during half and hour so that the
humidity excess is eliminated.
Maybe the cutlery have not been
washed correctly and have a slight
grease cloak. This cloak is causing
that remains come out. In this case
you must wash the cutlery correctly
again.
An excess of cutlery prevents that
the
carries
out
Remember that you should feed the
machine in handfuls of 12 or 5
pieces approximately leaving small
intervals among them.
Remember that the machine has
any
been
designed
polishing cutlery. We don´t advise to
introduce pieces too big
Disconnect the machine pushing the
red stop button, elevate the cover
carefully and retire the piece that
has produced the block
GB
that
it
change
the
a
good
work.
for
drying
and
.