Brabantia 481949 Instrucciones De Uso página 5

Measuring (select user manually)
1. Touch • to switch on the scales and touch < or > to select your personal user number. Wait until the LCD display shows 0.0.
2. Stand on the middle of the platform with bare feet.
3. Stand still – the weight data will be locked automatically when stable.
4. The measuring will start automatically with the indication bar moving from left to right.
5. After measuring, the results will be shown three times and then the scales will turn off automatically.
6. Put your measurements in the diary.
Measuring (select user automatically)
If your personal information is stored in the memory, the scales will determine your user number by the last measurement of your
weight.
1. Step onto the scales with bare feet to switch on the scales.
2. Stand still – the weight data will be locked automatically when stable.
3. If your weight is already stored in the scales memory, your user number will be selected automatically and the measurements will be
shown in cycles of three times and the scales will be turned off.
If there are other users of the scales whose weight data comes close to your weight, the display will show both user numbers after
calculation. You can select your user number by using < and > and touch • to confirm. If there are more users with approximately the
same weight, you have to select your personal user number manually.
lcd messages Problem
lO Low battery indication
--- Overload indication
ERR Measuring error
indication
ERR Failed identification
indication
What to do
when lo is shown, the scales will turn off after a few seconds - time to change
the batteries (4 x AAA/1.5 V).
Please remove the weight from the scales to protect the scales electronics.
The weight is shown only and the scales will turn off after a few seconds. Please
step on the scales with bare feet again and stand still until the weighing data is
stored. If the problem persists, try to slightly moisten your feet.
The weight is shown only and the scales will turn off after a few seconds. Please
select your Personal Number (e.g. P1) again and measure once again.