FULTON XLT 7.0 Manual De Instrucciones página 13

Read, understand and follow the warnings and instructions in
this manual.
Check all fasteners and verify they are at the proper torque.
Replace fasteners as needed.
Check wiring is correct and the connections are tight
Check there are no bare or exposed wires, terminals, or dam-
age to the cables (chafing/cutting). Repair or replace wires as
needed.
If damaged, discontinue use and replace strap immediately.
Keep winch, strap, and switch control free from contaminants.
Use a clean rag or towel to remove any dirt and debris.
3.2 Pairing Replacement Remote
The remote transmitter and receiver are paired and cannot be interchanged. If a wireless remote
(transmitter) is lost, a new one can pair itself to an existing receiver. The pairing method is as follows:
1. Turn on the remote control while simultaneously pressing the IN/OUT buttons. The wireless remote
will blink for 2 to 5 seconds and will change to a constant blue light. Your remote is now paired to
your winch.
2. If the red light flashes the control system should be serviced.
3.3 Lubrication
All moving parts in the winch are permanently lubricated at the time of assembly. Under normal condi-
tions factory lubrication will suffice. If re-lubrication of gear box is necessary after repair or disassem-
bly use Shell EP2 or equivalent grease. Never lubricate the brake system.
3.4 How To Order Replacement Parts
For Horizon Global Tech Service Department dial 1-800-632-3290.
WARNING
To prevent SERIOUS INJURY, DEATH and PROPERTY DAMAGE, you should read, understand
and follow the warnings and instructions in this manual.
For assistance with this product or to order replacement parts, please contact:
©2017 Horizon Global Americas Inc. •
Maintenance
Table 5 - Checklist
Horizon Global Americas Inc.,
47912 Halyard Dr. Suite 100
Plymouth, MI 48170
1-800-632-3290
http://www.fultonperformance.com/
Before First After
Operation EVERY Use
X
X
X
X
X X
X
F4088-00 REV B (7871) 11/17
Every
90 Days
X
X
X
X
13