Emptying The Dust Collector; Maintenance And Cleaning; Cleaning The Appliance; Replacing The Hepa Filter - Princess 332835 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
retrieve it again quickly when you need
it.
Maintenance
and cleaning
• Clean the appliance thoroughly after
use.
• Make sure the plug has been removed
from the plug socket before cleaning
the appliance.
• Make sure no moisture comes into
contact with the appliance's electrical
parts.
• Never immerse the appliance, the
power cord or the plug in water or
other liquids.
• Never use aggressive or scouring
cleaning products or sharp objects
(such as a knife or a hard brush) to
clean the appliance.

Cleaning the appliance

1 Remove the plug from the plug socket.
2 Clean the exterior of all the components
with a damp cloth. Only use cleaning
products that are suitable for plastic.
3 Dry the appliance and the accessories
thoroughly before storing them.
4 Over the course of time, dust and dirt
can accumulate around the wheel
axles, thereby preventing the wheels
from turning easily. They should,
therefore, be kept clean.

Emptying the dust collector

See figure 8.
The "Dust collector full" indicator indicates
when the dust collector must be emptied.
1 Remove the plug from the plug socket.
2 Remove the dust collector by lifting the
dust collector's handle and taking out
the dust collector.
3 Hold the dust collector above a rubbish
bin and press the dust collector base
unlocking button.
4 Make sure the dust collector is
completely empty. If necessary, shake
the dust collector to remove all the
waste.
5 Close the base of the dust collector by
clicking it into place.
6 Place the dust collector back into the
appliance. Push the handle of the dust
collector's cover down as far as
possible. This will lock the dust collector
in the appliance.

Replacing the HEPA filter

See figure 9.
Regularly check whether the HEPA filter is
blocked. If this is the case, clean the filter
or replace it with a new filter.
1 Remove the plug from the plug socket.
2 Remove the dust collector by lifting the
dust collector's handle and taking out
the dust collector.
3 Remove the waste from the dust
collector as described in 'Emptying the
dust collector'.
4 Remove the cover from the dust
collector (see figure 9A). Hold the cover
in one hand and use your other hand to
unscrew the dust collector by rotating it
clockwise. The arrow on the cover will
now be aligned with the arrow with the
picture
on the dust collector. Remove
the cover from the dust collector.
5 Remove the filter tube and the filter
from the dust collector's cover (see
figure 9B). Hold the cover in one hand
Cyclone Cleaner Article 332835 / 332836
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

332836

Tabla de contenido