Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Before first use
Mounting the wall bracket
WARNING!
Risk of electric shock, short circuit and damage to
property!
If you damage electrical lines, water lines or heating pipes while
drilling holes in walls, this may result in electric shock, cause a short-
circuit, water damage or damage to heating or water systems.
− Before drilling, ensure that there are no electric lines, water
lines or heating pipes running through the desired area.
− Observe the safety instructions for the drill you use.
• You can use the screws and wall anchors contained in the
• Before installation, check which installation material is suit-
1. Select the installation site for your wall bracket
Ensure the following in the process:
• that there is a properly installed socket nearby you can use to connect
the power adapter
chargeable batteries of the handheld vacuum cleaner in the wall bracket.
• that there is enough space above the wall bracket so that you can com-
fortably place the handheld vacuum cleaner on the wall bracket.
2. Hold the wall bracket up to the desired location and use the mounting holes
to mark the positions of the drill holes.
3. Use the marks to drill the drill holes.
4. Insert the wall anchors
5. Use the two screws
Using the wall bracket as a stationary charging station
If you mount the power adapter on the wall bracket and
connect it to the power supply, you can use the wall bracket as a
stationary charging station.
− Insert the device plug
so that the two guides on the wall bracket extend into the grooves on the
device plug (see Fig. D).
− Plug the power plug
14
pack contents if they are suitable for your wall composition.
able for your wall.
12
to the power supply. Thus, you can charge the re-
7
in the drill holes.
8
to fix the wall bracket on the wall.
10
in the designated recess on the wall bracket
11
into a properly installed socket.
(see Fig. A, C and D).
6
19
6
Publicidad
Capítulos
Tabla de contenido
