Wiring Diagrams - Fermax DUOX 3258 Manual De Instalador

DUO DUO X RISERS SPLITTER X RISERS SPLITTER
DUOX RISERS SPLITTER DUO DUO X RISERS SPLITTER X RISERS SPLITTER
DUO DUOX RISERS SPLITTER DUO X RISERS SPLITTER X RISERS SPLITTER X RISERS SPLITTER
DUO DUO X RISERS SPLITTER
WIRING DIAGRAM
- a) Powering only riser mode: in this mode the power reaches each of the risers.
The output risers are automatically powered by the power source and filtered by the
splitter. To use this operating mode it must be configured as followed:
• In this mode the SW1 switch must be in the OFF position.
• Connect the power source (18Vdc) to the splitter input +18V.
• Check that the red PWR LEDs are lit for the output risers B1 and B2.
• Connect the output risers B1 and B2. These must come from the PREV BUS from
filter ref.3243 or not be powered.
The input splitter (B/B) must be properly powered. Connect the input riser and
check that the red PWR LEDs are lit .
Page 8
a)
18V
18V
SW1 OFF
B/B
B1 B2