Built-In Cabinet Instructions - NODOR V24B Manual De Instrucciones

NOTE
: Make sure that the socket and ON/OFF
switch are easily
has been installed.

Built-in Cabinet Instructions

The wine cooler door seals the installed unit almost completely,
so an air vent must be provided in the base of the housing. War-
med air must be conducted via the ventilation shaft to the rear
wall of the housing and then expelled upwards. The ventilation
channels should measure at least 200 square centimeters in
cross-section.
1. Remove the door gasket on the side you wish
to install the handle - you can see two
designated holes for handle installation.
accessible after the appliance
2. Install the handle tightly as shown above with
two screws, lock washers and flat washers
provided.
WARNING
: To ensure the proper functioning of the
appliance, air vents should never be blocked or
covered.
Attention
• Store wine in sealed bottles.
• Do not overload the cabinet.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any
other shelf material which may prevent air
circulation.
• Should the wine cooler be left empty for long
periods it is suggested that the appliance is
unplugged, and after careful cleaning, leave the
door ajar to allow air to circulate inside the
cabinet in order to avoid possible condensation,
mold or odors forming.
3.Replace the door gasket.