Performing A Control Test - Roche Diagnostics Accu-Chek Performa Nano Instrucciones De Uso

4
Control Tests

Performing a Control Test

You need the meter with pre‑inserted activation chip*, a test strip, and control solution Level 1, Level 2,
or both. The control level is printed on the bottle label.
* The black activation chip is not for use with Accu‑Chek Inform II test strips. If you are using Accu‑Chek
Inform II test strips, remove the black activation chip and discard it. See the Accu‑Chek Inform II test
strip package insert for instructions on coding the meter.
1
Check the use by date Insert the test strip into
on the test strip the meter in the direction
container. Do not use of the arrows.
test strips past the
Place the meter on a flat
use by date.
surface.
5
Do not put control
solution on top of the
test strip.
When you see flash,
there is enough control
solution in the test strip.
Touch the drop to the
front edge of the yellow
window of the test strip
until you see flash.
28
53074_07214103002_EN.indb 28
2 3
or
Select the control
solution to test. You will
enter the level later in
the test.
6
Wipe the tip of the bottle
with a tissue. Cap the
bottle tightly.
4
Remove the cap from the
control solution bottle.
Wipe the tip of the bottle
with a tissue.
Squeeze the bottle until
a tiny drop forms at the
tip.
2/5/15 9:39 AM