GN Netcom Jabra SP700 Manual De Instrucciones página 13

Using FM transmitter when voice announcement function
is off
If voice announcement function is turned off you can select any of
the pre-programmed frequency channels in the following order:
Pre-
Channel
programmed
no
frequency
1 88 .1 mhz
2 88 .3 mhz
3 88 .5 mhz
4 88 .7 mhz
5 88 .9 mhz
6 89 .1 mhz
7 89 .3 mhz
To select the desired fm frequency channel, follow these steps:
- Connect your mobile phone and speakerphone .
- Press fm button to enter fm mode . The default frequency
channel is 88 .1mhz
- Press the volume up or volume Down button to move to the
next/previous channel .
- manually tune your radio to the same fm frequency and you
are now ready to transmit calls or music from your phone to
your car stereo .
note1: While changing frequencies, fm Status Indicator flashes
every 1 second .
note2: While changing frequencies, a repeated beep-tone will be
heard and frequencies can be recognized by the combinations of
Status Indicators . (See the table above .)
Caller ID
When you have an incoming call the speakerphone will announce
the number of the caller . If your radio supports rDS Text the
phone number will furthermore be showed on the radio display .
leD indication
(fm frequency selection mode)
battery Call
status status
off off
off on
on off
off on
on off
on on
on on
Jabra SP700
bluetooth fm
status status
on
off
off
on
flash
on
off
on
12